Table Tennis bat customisation
Table Tennis Equipment
Last updated 9 years ago
Mudit Sahai Asked 9 years ago
Hello Sir,
This is Mudit Sahai from INDIA.
I have been playing Table Tennis from last 2 years and have been using STAG POWER DRIVE PLUS which is a good customised BAT promising speed,spin of 85 and control 90.
I had been thinking of changing the backhand rubber with MARK V rubber but after watching the video (https://www.youtube.com/watch?v=ts15JPS1K-w) i got a doubt on it that shall i replace the rubber on my same blade(wood)or should i get a completely new blade and rubber.
Alois Rosario Answered 9 years ago
Hi Mudit,
I think putting Mark V on a pre made bat is OK in a lot of cases. I don’t know the quality of the blade you have now.
I have seen the PingSkills Rook with better rubber on it and it works really well. I would say, give it a try with the Stag bat as it seems to be at the higher end of their pre made bat range.
Thoughts on this question
Become a free member to post a comment about this question.
Ilia Minkin Posted 9 years ago
But be careful while removing an old rubber from a pre-made bat. When I tried to do that with my old Atemi bat it turned to be impossible without damaging it, the glue was so sticky.